![DOGCOM 5200mAh 6S 120C 22.2V LiPo Battery QS8 [DG]](http://ae.fpvfaster.com/cdn/shop/files/5200mAh120C6S22.2V_300x300.jpg?v=1719899749)
![Infinity 1400mAh 6S 150C 22.2V LiPo Battery XT60 [DG]](http://ae.fpvfaster.com/cdn/shop/files/Xnip2024-07-30_14-30-56_300x300.jpg?v=1722313885)
Matek F405-WSE Flight Controller Wing 30x30mm
FC Specifications
- MCU: 168MHz STM32F405RGT6 1MB Flash
- IMU: MPU6000 (SPI1)
- Baro: DPS310 (I2C1)
- OSD: AT7456E (SPI2)
- Blackbox: MicroSD socket (SPI3)
- VCP & 6x UARTs,
- 1x Softserial_Tx option (TX2 pad, INAV)
- 10x PWM outputs(S1~S9, LED)
- 2x I2C
- 3x ADC (voltage, current, RSSI)
- 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
- Built in inverter on UART2-RX for SBUS input
- PPM/UART Shared: UART2-RX
- 1x SH1.0_6pin connector (4V5/G/TX4/RX4/DA2/CL2) for GPS/compass
- 1x SH1.0_6pin connector for external USB and buzzer
- DJI FPV OSD: any spare UART
- FrskyOSD: any spare UART
Power
- 6~30V DC IN (2~6S LiPo)
- 132A high-precision Current Sense (Scale 250)
- PDB/Current sense resistor: 60A continuous, 132A burst.
- BEC 5V 2A for FC & Peripherals
- BEC Vx 5A for servos, 5V/ 6V option
- BEC 8V 1.5A for VTX and camera
- LDO 3.3V 200mA
- Battery Voltage Sensor: 1k:10k
FC Firmware
- INAV Target: MATEKF405SE
- ArduPilot hwdef: MATEKF405WING
Physical
- Dimensions: 44 x 29 x 10 mm
- Mounting: 25 x 25mm, Φ2mm
- Weight: 20g w/ bottom plate and USB/buzzer adapter
Including
- 1x FC F405-WSE
- 1x USB(Type-C)/Buzzer (Active) Adapter
- 1x Bottom plate, 44 x 29mm
- 2x JST-SH-6P to JST-SH-6P cables, 20cm
- 5x Brass standoffs, M2*4mm
- 10x screws, M2*3.5mm
- Dupont 2.54 pins (Board is shipped unsoldered)
